How To Replace Old Garage Door Springs

After your new door is installed remove the old stop material on the outside of the door and replace it with the type that has a rubber weatherstrip gasket available at home centers.

How to replace old garage door springs. There are two types of garage door springs. Part 1 of 2. Unplug the garage door opener and clamp the door to the track. If the door remains in place the replacement was a.

One cable attaches to the bottom of the door runs up and over the pulley above the door and around the spring pulley and then attaches to the door track bracket. Lubricate the spring with garage door lubricant then remove the clamp from the garage door. A new garage door is a diy project any homeowner can do with a couple of strong friends. Test the spring by lifting the door about 3 feet.

One at the end of each spring and one at the top of the vertical door track they also have two cables on each side. For doors with torsion springs located over the door spend the 50 or so to have a garage door professional release the tension. Use locking pliers or a c. A couple of carabiners can.

A pair of new springs cost about 25. Replacing your own garage door springs takes only a little time and effort and can save you hundreds of dollars. Disconnect the garage door opener so the door remains closed. After removing the old door installing the new door is done by stacking the door panels one at a time and fitting the.

How to replace a garage door.