How To Test A Ford Door Lock Actuator

It is held on by a bracket that is riveted onto the side of the door.

How to test a ford door lock actuator. When the tab is sufficiently raised slide the actuator toward you and off the latch. If it is the front door then attempt the lock unlock the door while you are real close to the unit to hear or feel if it is attempting to move but can t etc. Ok first of all take off the door panel. Sometimes a door lock actuator stops working completely.

Quick way to test the door actuator locking latching unit imo is to remove both door panels from the front and rear doors on the side in question. Reinstall the t27 screws near the latch to hold it in place. By pressing on the unlock button on the door panel cluster. Point the lock rod up and push the new actuator in place.

It is not necessary to remove the smaller panel underneath the main door panel. Door lock actuators sold here. If the door remains locked in either or both of these cases the problem is the actuator. Unclip the wiring harness from the actuator.

The actuator is on the lower left hand side. Plug in power for the actuator and other electrical connections. Hold the latch firmly and pry up on the spring tab which holds the actuator to the latch. Unplug the door lock actuator electrical connector.

Just a short video to show how you can test a door lock actuator using a car battery or a car jumper. There are several reasons why a door lock actuator may need to be replaced. Then use your test light or digital meter to check for power and ground at the connector when you operate the lock unlock switch. Reverse the left and right directions for the passenger side door.

You can get a better idea of where the screwdriver needs to go by using your flashlight and mirror to see the actuator s position inside the door. The door lock actuator is held into the door by a bracket. You should see the voltage polarity toggle with each switch activation. Lift the tab and unplug the electrical connector from the actuator.

Push the bottom clip back in the door. Pry the actuator off of the bracket with a small flat blade screwdriver. Reconnect the harness and feed the assembly back in the door. If the rods are connected properly the door will lock and unlock.